Vetrimec (ivermectin) Pour-On delivers internal and external parasite control in one convenient low-volume application.
Shipping : Flat
Kills: Roundworms, (including Brown Stomach Worms), Lungworms, Grubs, Sucking Lice, Biting Lice, Mange Mites, Horn Flies
Consult your veterinarian for assistance in the diagnosis, treatment and control of parasitism.
| Directions | The dispensing cap is graduated in 5 mL increments. Each 5 mL will treat 110 lbs body weight. When body weight is between markings, use the next higher increment. Attach the dispensing cap to the bottle. Select the correct dose rate by rotating the adjuster top in either direction to position the dose indicator to the appropriate level. Hold the bottle upright and gently squeeze it to deliver a slight excess of the required dose as indicated by the calibration lines. By releasing the pressure, the dose automatically adjusts to the correct level. Tilt the bottle to deliver the dose. The âclosed-off-shutâ position will close the system between dosing. If the animal being treated weighs more than 550 lbs (250 kg), refill the dispensing cap to the additional amount required to provide the total dose for that animal and apply as directed. Because of the solvents used in Vetrimec Pour-On, the applicator gun from Simcro Tech, or equivalent, is recommended. Other applicators may exhibit compatibility problems resulting in locking, incorrect dosage or leakage. Screw Feedlot pack cap and dip tube onto the 20 liter drum ensuring a tight fit. Connect the long 3m feed tube at one end to the spigot on the Feedlot pack cap and the other end to the applicator gun. Then follow the applicator gun manufacturerâs directions for priming the gun, adjusting the dose, and care of the applicator gun following use. Because of the solvents used in Vetrimec Pour-On, the draw-off device and applicator gun from Simcro Tech, or equivalent, is recommended. Other applicators may exhibit compatibility problems resulting in locking, incorrect dosage or leakage. Screw Feedlot pack cap and dip tube onto the 20 liter drum ensuring a tight fit. Connect the long 3m feed tube at one end to the spigot on the Feedlot pack cap and the other end to the applicator gun. Then follow the applicator gun manufacturerâs directions for priming the gun, adjusting the dose, and care of the applicator gun following use. When the interval between use of the applicator gun is expected to exceed 12 hours, disconnect the gun, draw off tubing and dip tub and cap from the product container, empty the product from the gun and tubing back into the container and replace the shipping cap. |
|---|
